@old7even/ssp/lib/static/reject_note.json

Node.JS library Encrypted Smiley ® Secure Protocol (eSSP, SSP)

{
  "0": {
    "name": "NOTE_ACCEPTED",
    "description": "The banknote has been accepted. No reject has occured."
  },
  "1": {
    "name": "LENGTH_FAIL",
    "description": "A validation fail: The banknote has been read but it's length registers over the max length parameter."
  },
  "2": {
    "name": "AVERAGE_FAIL",
    "description": "Internal validation failure - banknote not recognised."
  },
  "3": {
    "name": "COASTLINE_FAIL",
    "description": "Internal validation failure - banknote not recognised."
  },
  "4": {
    "name": "GRAPH_FAIL",
    "description": "Internal validation failure - banknote not recognised."
  },
  "5": {
    "name": "BURIED_FAIL",
    "description": "Internal validation failure - banknote not recognised."
  },
  "6": {
    "name": "CHANNEL_INHIBIT",
    "description": "This banknote has been inhibited for acceptance in the dataset configuration."
  },
  "7": {
    "name": "SECOND_NOTE_DETECTED",
    "description": "A second banknote was inserted into the validator while the first one was still being transported through the banknote path."
  },
  "8": {
    "name": "REJECT_BY_HOST",
    "description": "The host system issues a Reject command when this banknote was held in escrow."
  },
  "9": {
    "name": "CROSS_CHANNEL_DETECTED",
    "description": "This bank note was identified as exisiting in two or more seperate channel definitions in the dataset."
  },
  "10": {
    "name": "REAR_SENSOR_ERROR",
    "description": "An inconsistency in a position sensor detection was seen"
  },
  "11": {
    "name": "NOTE_TOO_LONG",
    "description": "The banknote failed dataset length checks."
  },
  "12": {
    "name": "DISABLED_BY_HOST",
    "description": "The bank note was validated on a channel that has been inhibited for acceptance by the host system."
  },
  "13": {
    "name": "SLOW_MECH",
    "description": "The internal mechanism was detected as moving too slowly for correct validation."
  },
  "14": {
    "name": "STRIM_ATTEMPT",
    "description": "The internal mechanism was detected as moving too slowly for correct validation."
  },
  "15": {
    "name": "FRAUD_CHANNEL",
    "description": "Obselete response."
  },
  "16": {
    "name": "NO_NOTES_DETECTED",
    "description": "A banknote detection was initiated but no banknotes were seen at the validation section."
  },
  "17": {
    "name": "PEAK_DETECT_FAIL",
    "description": "Internal validation fail. Banknote not recognised."
  },
  "18": {
    "name": "TWISTED_NOTE_REJECT",
    "description": "Internal validation fail. Banknote not recognised."
  },
  "19": {
    "name": "ESCROW_TIME-OUT",
    "description": "A banknote held in escrow was rejected due to the host not communicating within the timeout period."
  },
  "20": {
    "name": "BAR_CODE_SCAN_FAIL",
    "description": "Internal validation fail. Banknote not recognised."
  },
  "21": {
    "name": "NO_CAM_ACTIVATE",
    "description": "A banknote did not reach the internal note path for validation during transport."
  },
  "22": {
    "name": "SLOT_FAIL_1",
    "description": "Internal validation fail. Banknote not recognised."
  },
  "23": {
    "name": "SLOT_FAIL_2",
    "description": "Internal validation fail. Banknote not recognised."
  },
  "24": {
    "name": "LENS_OVERSAMPLE",
    "description": "The banknote was transported faster than the system could sample the note."
  },
  "25": {
    "name": "WIDTH_DETECTION_FAIL",
    "description": "The banknote failed a measurement test."
  },
  "26": {
    "name": "SHORT_NOTE_DETECT",
    "description": "The banknote measured length fell outside of the validation parameter for minimum length."
  },
  "27": {
    "name": "PAYOUT_NOTE",
    "description": "The reject code cammand was issued after a note was payed out using a note payout device."
  },
  "28": {
    "name": "DOUBLE_NOTE_DETECTED",
    "description": "Mote than one banknote was detected as overlayed during note entry."
  },
  "29": {
    "name": "UNABLE_TO_STACK",
    "description": "The bank was unable to reach it's correct stacking position during transport"
  }
}